AHR 2014 - New York
Booth #759
Jan 21 - Jan 23

Made in the USA

Home Products Model #s Discontinued Orders About Site Map


   

 

[ 605-24 ] [ 610-012A ]

605-24
Electric Voltage Monitor

The Electric Voltage Monitor protects equipment (motor or compressor) by monitoring incoming line voltage. The monitor automatically disconnecting the protected equipment from the line in the event of the following occurrences:

   •  Phase Loss (Single Phase)

   •  Low Voltage (Brownout)

   •  High Voltage (Overvoltage)

   •  Imbalance (Voltage)

   •  Contactor Failure

 

Applications

Provides protection against the premature electrical failure of three phase motors and includes "short cycle" protection for compressors.  This controller is especially suited for protection of compressors utilized in HVACR  installations.  It can be used on any three phase motor rated at 208, 230, 240, 460 and 480 Volts.

Features

    •  Monitors load side of contactor for failure 

    •  Identifies failure type

       –  Red LED indicates fault status

       –  Green LED indicates normal operation

    •  Protects against nuisance trips

    •  Automatically resets up to three times

    •  Built in short cycle protection

    •  Lockout occurs after three default starts

    •  Manual reset required

 

605-24 Product Data

605-24 Installation & Operating Instructions
 

[ Home ] [ Products ] [ Model #s ] [ Discontinued ] [ Orders ] [ About ] [ Site Map ]

Copyright © 2012 Hoffman Controls Corp
HCC 2013.04.14